![gnuplot for mac install gnuplot for mac install](https://images01.nicepage.com/page/26/19/static-site-generator-preview-2619300.jpg)
UPDATE: Thanks to some feedback, I failed to note that you should install X11 and XCode before attempting to install MacPorts. They should start some funny rumors since their credibility is so high right now. I have no reason to doubt anything they say considering how simple this all was. I've only done this on 10.5, but MacPorts claims to support the latest OS, and the last release (10.4 for now). If there are any questions, leave a comment. Just start the terminal up and type 'gnuplot'. I'll warn you, this installation can take a while (~30 minutes) as you download and install all the smaller software packages required. Then I installed gnuplot-4 by clicking the installer package. I have installed aquaterm 1.0.1 and this works fine. Hopefully someone recognizes them and can help.
GNUPLOT FOR MAC INSTALL MAC OS X
At that point, it's as easy as typing 'sudo port install gnuplot' in the Terminal. I am using Mac OS X 10.4.9 and am trying to install gnuplot-4 but I run into some problems. Once MacPorts has been installed, you'll need to start a new Terminal session.Installation of MacPorts is a breeze once you download their disk image (.dmg) and run their installer (.mpkg), which you can get here. MacPorts allows you to install a number of software packages by simply typing 'install packagename' in the Terminal. MacPorts: Probably one of the coolest things ever, simple as hell, and quite powerful.To be honest, that entry alone has all the information you really need, but it assumes some basic awareness of a few things I hadn't heard about before, so I thought I'd post this information in a more outright manner. I searched on the web for a while for some help which was fruitless until I stumbled upon this little nugget, which was a great relief, as I tend to be sort of lazy when sifting through readme's. However, after downloading, extracting, and messing around in the terminal I found latest build (4.2.4) was having some issues with the makefile, even after configuration. So, there I was, looking lustfully at the gnuplot demos, so rich in their 3D visualization options.